Kenmore 46-9980 Refrigerator Water Filter 3-Pack | LG LT1000P Equivalent | Fits ADQ74793501 & MDJ64844601
- MPN:
- 9980
- Condition:
- New
- Bulk Pricing:
- Buy in bulk and save
- Buy 2 - 3 and get 10% off
- Buy 4 - 5 and get 12% off
- Buy 6 or above and get 15% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
Kenmore 46-9980 Refrigerator Water Filter | LG LT1000P Equivalent | Fits ADQ74793501 & MDJ64844601
The 46-9980 is the Kenmore part number for the filter LG sells as the LT1000P. It is a short twist-in cartridge that mounts inside the fresh food compartment.
It is not interchangeable with the Kenmore 46-9690 (LG LT700P) or the Kenmore 46-9490 (LG LT800P). Those are different lengths and different bayonet fittings. The quickest check: pull your current filter and read the number printed on the label, or look up the filter part number in your owner's manual.
On Kenmore Elite and LG French door refrigerators, this filter twists into the ceiling of the fresh food compartment, in the upper right-hand corner behind a small hinged cover. It filters both the dispenser water and the water feeding the ice maker.
It is a water filter only. If your refrigerator also has a fresh-air cartridge in the rear wall, that is a separate part (Kenmore 46-9918 / LG LT120F) and is not included here.
Product Description
The Kenmore 46-9980 is the replacement water filter for Kenmore Elite 795-series French door refrigerators and the LG French door models they are built from. It uses an activated carbon block to reduce chlorine taste and odour and to trap sediment and fine particles, so dispensed water tastes cleaner and ice comes out clear instead of cloudy.
This is the same cartridge sold under the LG part number LT1000P and the factory numbers ADQ74793501, ADQ74793502 and MDJ64844601. If your old filter carries any of those markings, this is the correct replacement.
Rated for approximately 200 gallons or six months of normal household use, whichever comes first. Installation is a quarter-turn twist — no tools, no shutting off the water supply, and no disassembly of the shelving.
Key Features
- Reduces chlorine taste and odour for better-tasting drinking water and clearer ice
- Traps sediment and fine particles carried in the supply line
- Six-month service life — roughly 200 gallons under typical household use
- Twist-in fitting — installs in under a minute with no tools and no water shut-off
- Filters water and ice from a single cartridge
- Direct replacement for ADQ74793501, ADQ74793502, MDJ64844601 and LG LT1000P
Filter Specifications
| Specification | Detail |
|---|---|
| Kenmore part number | 46-9980 / 9980 |
| LG equivalent | LT1000P |
| Rated capacity | Approx. 200 gallons |
| Service life | 6 months, or sooner if flow slows |
| Flow rate | 0.5 gpm (1.9 lpm) |
| Operating pressure | 20 – 120 psi |
| Operating temperature | 33°F – 100°F |
| Dimensions | Approx. 7 in. long × 2 in. diameter |
| Filter type | Twist-in activated carbon block, interior mount |
Compatible Refrigerator Models
Model lists vary by production run and suffix letters denote finish rather than fitment. If your model is not shown, check the number printed on your existing filter — if it reads 9980, LT1000P, ADQ74793501, ADQ74793502 or MDJ64844601, this cartridge is the correct fit.
Alternate Part Numbers
9980, 46-9980, 469980, 04609980000, LT1000P, LT1000PC, LT1000PCS, LT-1000PC, ADQ74793501, ADQ74793502, ADQ74793504, ADQ74793506, ADQ74793507, ADQ7493502, ADQ75795105, ADQ76793501, AGF80300704, AGF80300806, AGM76550101, MDJ64844601, 4547277, AP6985097, PS12724834, EAP12724834, PD00053178
Installation
- Open the fresh food compartment and locate the filter cover in the upper right-hand corner of the ceiling. Lift or swing the cover open.
- Turn the old cartridge counter-clockwise about a quarter turn and pull it straight down. A small amount of water may drip — have a cloth ready.
- Remove the protective cap from the new filter. Do not soak or pre-rinse the cartridge.
- Push the new filter up into the housing and turn it clockwise until it stops and sits flush. It should feel firmly seated, not loose.
- Close the cover and dispense approximately 2.5 gallons of water — about five minutes of running the dispenser — to purge trapped air and loose carbon fines. Spluttering and grey-tinted water during this stage are normal.
- Reset the filter indicator: press and hold the filter reset button on the dispenser panel for about three seconds until the light changes from red to green.
- Discard the first two full batches of ice produced after the change.
Replacement Schedule
| Household | Typical usage | Change filter |
|---|---|---|
| 1 – 2 people | Light dispenser and ice use | Every 6 months |
| 3 – 4 people | Daily drinking water and ice | Every 5 – 6 months |
| 5+ people | Heavy dispenser and ice use | Every 4 – 5 months |
| Any household | Well water or high sediment supply | Every 3 – 4 months |
| Any household | Flow noticeably slower, or taste returns | Change immediately |
Frequently Asked Questions
Is the Kenmore 46-9980 the same filter as the LG LT1000P?
Yes. Kenmore Elite refrigerators in this range are built by LG, and 46-9980 is the Kenmore catalogue number for the same cartridge LG lists as LT1000P. The factory part numbers ADQ74793501, ADQ74793502 and MDJ64844601 refer to the same filter.
What is the difference between LT1000P, LT1000PC and LT1000PCS?
They are the same physical water filter. The suffixes refer to bundling — some versions were packaged together with the matching fresh-air cartridge. Fitment is identical.
Will this fit if my old filter says 9690 or 9490?
No. Kenmore 46-9690 (LG LT700P) and 46-9490 (LG LT800P) are physically different cartridges and will not seat in a housing designed for the 9980. Match the number on your existing filter rather than the refrigerator's age or size.
My water is coming out slowly. Does that mean the filter is bad?
A gradual drop in flow is the normal end-of-life signal for a carbon filter as the media loads with sediment. If flow has slowed noticeably before the six-month mark, change it early. A sudden stop right after installation usually means the cartridge is not fully seated — remove it and re-fit it with a firm clockwise turn.
Why is the water cloudy or grey after I fit a new filter?
Trapped air and a small amount of harmless carbon dust are released when the cartridge first fills. Flushing about 2.5 gallons through the dispenser clears it. If cloudiness persists past that, keep flushing in short bursts.
Do I have to reset the filter light?
The indicator runs on a timer, not a sensor, so it will not clear on its own. Hold the filter reset button on the dispenser panel for roughly three seconds after installation. On some models the button is labelled with a filter icon rather than the word "filter".
Does this filter the ice maker as well as the dispenser?
Yes. On these models a single cartridge sits upstream of both the dispenser and the ice maker line.
Can I run the refrigerator without a filter installed?
Most models in this range require either a filter or the factory bypass plug in the housing for the dispenser to run. Without one of the two, water flow to the dispenser and ice maker is blocked.