Kenmore 46-9911 Refrigerator Water Filter 2-Pack | Replaces Frigidaire WF2CB, PureSource 2 & FC-100
- MPN:
- 9911
- Condition:
- New
- Bulk Pricing:
- Buy in bulk and save
- Buy 2 - 3 and get 10% off
- Buy 4 - 5 and get 12% off
- Buy 6 or above and get 15% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
Check the shape of your old filter first. The 46-9911 is a flat, rectangular slide-out cassette — not a round cylinder. If the filter you are pulling out is a tall round cartridge that twists into a socket, you need a different part: the 46-9999 (Frigidaire ULTRAWF / PureSource Ultra) or the 46-9906 (Frigidaire WF3CB / PureSource 3). Kenmore refrigerators whose model number begins with 795 are built by LG and do not use this filter at all.
Where this filter goes: the 46-9911 is a PureSource 2 cassette that slides horizontally into a housing at the front top-right corner of the fresh food compartment, just above the top shelf. On a small number of older units the same housing sits in the front base grille at the bottom of the refrigerator. It is a push-in, push-to-release design — there is nothing to twist.
Kenmore 46-9911 Refrigerator Water Filter (Frigidaire WF2CB / PureSource 2)
The Kenmore 46-9911 is the water filter cassette used in Kenmore side-by-side refrigerators built by Frigidaire — the ones whose model number starts with 253. It is the same physical filter sold under the Frigidaire part number WF2CB, marketed as the PureSource 2 system, and it also carries the older codes FC-100, 240396401 and NGFC 2000 depending on which parts catalog you are looking at.
Because Sears sourced its Kenmore refrigerators from several different manufacturers, the filter part number is the only reliable way to shop. Anything labelled 46-9911, 469911, 9911, 46-9916 or 9916 is this filter. If your old cassette shows any of those numbers, this is a direct swap.
Inside is an activated carbon block that reduces the chlorine taste and odor that makes tap water and ice taste flat or swimming-pool-like, along with sediment and fine particulate that can cloud a glass or leave grit in the ice bin. Replace it roughly every six months to keep flow rate and taste consistent.
Key Features
- Direct replacement for Kenmore 46-9911, 46-9916 and Frigidaire WF2CB / PureSource 2
- Activated carbon block media reduces chlorine taste, odor and sediment
- Slide-out cassette design — push in, push to release, no tools and no twisting
- Six-month service life under typical household use
- Fits the front top-right housing used across Kenmore 253-series, Frigidaire, Electrolux, Gibson and Westinghouse side-by-sides
- Feeds both the door dispenser and the ice maker from a single cartridge
Compatible Refrigerator Models
The PureSource 2 housing appears across hundreds of individual model and revision codes. Below are the model families that use this filter. Match the leading characters of your model number — the trailing digit or letter is a revision suffix and does not change filter fitment.
Alternate Part Numbers
This filter is cross-referenced under the following codes. If your old cartridge, owner's manual or parts diagram lists any of these, the 46-9911 is the correct replacement.
How to Install the 46-9911
- Open the fresh food door and look at the front top-right corner, just above the top shelf, for a narrow plastic door or grille. On some older units this housing is instead in the base grille at the bottom front of the refrigerator.
- Open the filter door. It either swings down on a hinge or pops open when you press the front face of the cartridge.
- Push the old cassette in about a quarter inch and release. The clip behind it lets go and the cartridge springs partway out. Pull it the rest of the way and discard it. A small amount of water may drip — have a towel ready.
- Check the orientation of the new filter. The label faces out and the arrow or notch on the housing indicates which way up it goes. It only seats one way.
- Slide the new cassette straight in and push firmly until you feel it stop against the clip at the back of the housing and hear it click. Do not twist it.
- Close the filter door and confirm it latches flush.
- Flush the system. Run about two to three gallons through the dispenser, pausing every 30 seconds, until the water runs clear and the sputtering stops. That air in the line is normal for a new cartridge.
- Discard the first full batch of ice after the change, then reset the filter indicator light if your model has one — usually by holding the filter or reset button for three seconds.
Replacement Schedule
| Household | Typical replacement interval | Notes |
|---|---|---|
| 1–2 people | Every 6 months | Standard interval even at low usage — carbon media degrades with time as well as volume |
| 3–4 people | Every 5–6 months | The most common household case |
| 5+ people, or heavy ice use | Every 4–5 months | High dispenser and ice maker throughput shortens usable life |
| Well water or visibly cloudy supply | Every 3–4 months | Higher sediment load clogs the media faster |
| Any household | Immediately | If dispenser flow drops noticeably or chlorine taste returns |
Frequently Asked Questions
Is the 46-9911 the same as the Frigidaire WF2CB?
Yes. They are the same physical cassette for the same PureSource 2 housing. The 46-9911 number was used on Sears-branded packaging; WF2CB is the Frigidaire number. Either one fits.
My old filter says 9916 — will this work?
Yes. 46-9916 and 9916 are alternate codes for the same cartridge. Some Sears catalogs listed the filter under both numbers.
My Kenmore model number starts with 795. Does this fit?
No. Kenmore refrigerators in the 795 series are manufactured by LG and use a completely different round cartridge — typically an LT-series filter. This cassette will not fit those housings.
How do I find my refrigerator model number?
Open the fresh food door and check the label on the interior left wall, on the ceiling of the compartment, or behind the crisper drawers. On Kenmore units it starts with a three-digit prefix followed by a period. That prefix tells you who built the unit: 253 is Frigidaire, which is what this filter fits.
Do I need to shut off the water supply first?
Not for this design. The housing has an internal shut-off that stops flow when the cassette is removed. If you are working on the housing itself rather than just swapping the cartridge, shut off the supply valve behind the refrigerator.
Why is my water sputtering after the change?
Air trapped in the new cartridge and the line. Run two to three gallons through the dispenser in short bursts and it clears. This is expected on every filter change.
Can I run the refrigerator without a filter?
Most PureSource 2 models need either a filter or a bypass plug installed for the dispenser and ice maker to work. Without one, flow may stop entirely. Frigidaire's bypass for this housing is part 242227702.
Does the filter feed the ice maker as well as the dispenser?
Yes. A single cartridge handles both, which is why ice quality drops off at the same time dispenser taste does.
Kenmore
Kenmore 46-9911 Refrigerator Water Filter | Replaces Frigidaire WF2CB, PureSource 2 & FC-100
Kenmore
Kenmore 46-9999 Refrigerator Water Filter 2-Pack | Replaces Frigidaire ULTRAWF PureSource Ultra
Frigidaire
Frigidaire ULTRAWF PureSource Ultra Refrigerator Water Filter 2-Pack | Compatible Replacement | Kenmore 46-9999
Kenmore
Kenmore 46-9999 Refrigerator Water Filter | Replaces Frigidaire ULTRAWF PureSource Ultra
Frigidaire
Frigidaire ULTRAWF PureSource Ultra Refrigerator Water Filter | Compatible Replacement | Kenmore 46-9999