GE XWF Refrigerator Water Filter (WR17X30702) 2-Pack | No RFID Chip | Fits GDE21, GNE25, GNE27, GSS25
- MPN:
- XWF
- Bulk Pricing:
- Buy in bulk and save
- Buy 2 - 3 and get 10% off
- Buy 4 - 5 and get 12% off
- Buy 6 or above and get 15% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
GE XWF Refrigerator Water Filter — WR17X30702
The GE XWF is the twist-in replacement water filter for GE refrigerators built after June 2018 that use a non-chip cartridge. It sits inside the fresh food compartment, in the upper right corner, and feeds both the water dispenser and the ice maker.
Fitting it takes under a minute. There are no tools involved, no water shut-off, and no filter housing to unscrew — the old cartridge twists out, the new one twists in and locks. A coconut shell carbon block core reduces chlorine taste and odour and traps sand, rust and sediment, so dispensed water and ice taste clean instead of flat or metallic.
One cartridge is rated for six months or 170 gallons, whichever comes first. Most households replace on the calendar; larger households that go through a lot of ice usually hit the gallon figure first and notice it as a slower dispenser or a change in taste.
Key Features
- No RFID chip: Built for GE refrigerators that do not require chip authentication — no error message, no dispenser lockout
- Better tasting water and ice: Reduces chlorine taste and odour so water tastes fresh from the first glass
- Sediment filtration: Captures sand, rust and fine particulates that make water look cloudy or leave grit in ice
- 170 gallons or 6 months: Rated cartridge life for a typical household
- Tool-free twist-in fit: No water shut-off, no tools, no disassembly — roughly 60 seconds start to finish
- Coconut shell carbon block: Dense carbon core with a food-grade housing and a positive twist-lock seal
- Wide GE coverage: Fits GE, GE Profile and Café French door, side-by-side and bottom-freezer models built after June 2018
Specifications
| Part number | XWF / WR17X30702 |
| Filter type | Twist-in cartridge, carbon block |
| RFID chip | None |
| Location | Inside refrigerator compartment, upper right |
| Rated life | 6 months or 170 gallons |
| Installation | Tool-free, no water shut-off required |
| Fits fridges built | After June 2018 |
Not Sure Which GE Filter You Need?
- Filter labelled XWF, inside the fridge, no chip → this filter
- Filter labelled XWFE, inside the fridge, chip on the collar → you need the XWFE
- Filter pulls out of the base grille at the bottom of the fridge → you need MWF, RPWF or RPWFE
The quickest confirmation is the printed label on the cartridge you are removing. Your owner's manual and the sticker inside the filter housing will also list the correct part number.
Compatible Refrigerator Models
Fits GE, GE Profile and Café refrigerators built after June 2018 that use the XWF cartridge. Match the first characters of your model number, found on the sticker inside the fresh food compartment.
French Door Models
Side-by-Side Models
GE Profile & Café Models
Frequently Requested Full Model Numbers
Alternate Part Numbers
XWF, WR17X30702, EFF-6048A, RWF5200A, RWF1065, CWMF034, AQF-XWF, SP-GSXW, FF21140, WD-XWF, PL-4100, FL-RF48, OB6048, CF9, AL-XWF, MB-XWF
How to Install the GE XWF Filter
- Open the fridge and look up and right. The cartridge sits in the upper right corner of the fresh food compartment. There is no need to turn off the water supply.
- Twist the old filter out. Turn it roughly a quarter turn counter-clockwise, then pull it straight out. A small amount of water may drip — keep a cloth handy.
- Twist the new filter in. Push it into the housing and turn clockwise until it stops and sits flush.
- Flush about two gallons. Run the dispenser for roughly five minutes to clear trapped air. Cloudy or sputtering water at first is normal and clears as the air works out.
- Dump the first two batches of ice. The first ice made after a filter change can taste off.
- Reset the filter indicator. Press and hold the reset button on the dispenser panel until the light clears, usually about three seconds.
When to Replace
| Trigger | What to do |
|---|---|
| Every 6 months | Replace on schedule — this is the standard interval for most households |
| After 170 gallons | Replace, whichever comes first |
| Indicator light turns red or orange | Replace and reset the indicator |
| Dispenser flow slows down | Replace now — a slow dispenser usually means a loaded cartridge |
| Water or ice tastes or smells off | Replace now |
Frequently Asked Questions
How do I know whether my fridge takes the XWF or the XWFE?
Read the label on the cartridge you are pulling out. XWF or WR17X30702 means this filter. XWFE means the chip-enabled version. You can also check the sticker inside the filter housing or your owner's manual.
What happens if I fit an XWF in a fridge that needs the XWFE?
The refrigerator will not recognise the cartridge. Depending on the model you will see a filter error on the display or the dispenser will stop supplying water. Fitting the correct cartridge clears it.
Where is the filter on my GE refrigerator?
Inside the fresh food compartment, upper right corner. If yours pulls out of the grille at the bottom of the fridge, it is a different GE filter — most likely MWF, RPWF or RPWFE.
Do I need to turn off the water before changing it?
No. The housing seals itself when the cartridge comes out. Expect a few drops of water and nothing more.
Why is my water cloudy after fitting a new filter?
Air trapped in the new cartridge. It clears once you have run about two gallons through the dispenser.
How long does one filter last?
Six months or 170 gallons, whichever comes first. Households that use a lot of ice or dispensed water usually reach the gallon figure before the six months are up.
GE
GE XWF Refrigerator Water Filter (WR17X30702) 3-Pack | No RFID Chip | Fits GDE21, GNE25, GNE27, GSS25
