GE GSWF SmartWater Refrigerator Water Filter 3-Pack | Kenmore 46-9914 | Fits GE GTS, GTH, PDS, PFS & PTS Refrigerators
- MPN:
- GSWF3PK
- Condition:
- New
- Bulk Pricing:
- Buy in bulk and save
- Buy 2 - 3 and get 10% off
- Buy 4 - 5 and get 12% off
- Buy 6 or above and get 15% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
GE GSWF SmartWater Refrigerator Water Filter | Kenmore 46-9914 | Fits GE GTS, GTH, PDS, PFS & PTS Refrigerators
The GSWF is a slim interior cartridge used in GE top-freezer, bottom-freezer and French-door refrigerators. It is not interchangeable with the MSWF or MWF / MWFP filters used in GE side-by-side models such as the GSH, GSL, GSS and PSS series — those cartridges are a different size and will not seat in a GSWF holder.
If your refrigerator is a side-by-side, see our GE MSWF listing or browse all GE water filters. Match your full refrigerator model number to the list below before adding to cart.
The GSWF installs inside the fresh-food compartment, in a cartridge holder behind a hinged cover — usually along the upper right wall on top-freezer models, or in the upper-left/rear area on bottom-freezer and French-door models. It seats with a quarter-turn twist and needs no tools.
If your filter is mounted behind the base grille at the bottom of the refrigerator, or in the rear top-right corner of a newer French-door model, you need an RPWF / RPWFE or XWF / XWFE instead.
About the GE GSWF Filter
The GE GSWF SmartWater cartridge is the factory-specified replacement filter for a wide range of GE, GE Profile and Café refrigerators built with the slim interior filter housing, and it is the same filter Kenmore lists under part number 46-9914. It reduces chlorine taste, odor and sediment in your drinking water and ice, so both taste noticeably cleaner than unfiltered supply water.
Because the cartridge is designed around GE's twist-and-lock holder, it seats squarely on the first attempt and seals without the leaks and drips that generic cartridges often cause. Replacement takes under a minute and requires no tools, no shut-off valve, and no draining of the water line.
GE rates the GSWF at 300 gallons or six months of use, whichever comes first. For most households that works out to two cartridges per year — a small fraction of the cost of bottled water over the same period.
Key Features
- Reduces chlorine taste, odor and sediment in both dispensed water and ice.
- Built for the GE slim interior housing — correct diameter, blade orientation and seal geometry for a first-try fit.
- Twist-and-lock installation — quarter-turn in, quarter-turn out, no tools and no water shut-off required.
- 300-gallon / 6-month rated service life under normal household use.
- Covers the Kenmore 46-9914 / 469914 / 9914 part numbers, so Kenmore-badged GE-built refrigerators are covered by the same cartridge.
- Maintains full dispenser flow rate when replaced on schedule.
Compatible Refrigerator Models
The prefixes below cover all colour and revision suffixes. Match the first 8 characters of your refrigerator's model number — for example, GTS18KHPDRWW is covered by the GTS18KHP entry.
Alternate Part Numbers
GSWF, GSWFDS, GSWF3PK, 238C2334P001, 215C1152P002, 100749-C, 100749C, 100810A, 100810/A, 35917-MN-1, 1042145, AP3418061, PS951515, AH951515, EA951515, WR01L04640, WR17X11608, WF281, WF282, WF298, 46-9914, 469914, 9914
How to Install
- Open the filter cover inside the fresh-food compartment by pushing in where indicated. The cover rotates roughly a quarter turn.
- Turn the old cartridge counter-clockwise about a quarter turn and pull it straight out. A small amount of water may drip — have a towel ready.
- Remove the protective caps from the new GSWF cartridge.
- Slide the new cartridge into the holder and rotate it clockwise until it stops. When seated correctly the gripping blade sits vertically on top-freezer models and horizontally on bottom-freezer models.
- Close the filter cover.
- Run roughly 1.5 gallons (about 5 minutes) through the dispenser to purge trapped air and carbon fines. Sputtering and grey-tinted water during this step are normal.
- Discard the first two batches of ice made after replacement.
- Reset the filter indicator by holding the reset button for about three seconds, if your model has one.
Replacement Schedule
| Household use | Typical replacement interval |
|---|---|
| 1–2 people, light dispenser use | Every 6 months |
| 3–4 people, regular water and ice use | Every 5–6 months |
| 5+ people, or heavy ice production | Every 3–4 months |
| Well water or visibly sediment-heavy supply | Every 3 months, or sooner if flow drops |
Replace sooner than scheduled if dispenser flow slows noticeably or the chlorine taste returns — those are the two most reliable signals, regardless of what the indicator light says.
Frequently Asked Questions
Is the GSWF the same as the MSWF?
No. They look broadly similar but are different lengths and are not interchangeable. The GSWF is used in top-freezer, bottom-freezer and French-door models; the MSWF is used in GE side-by-side models such as the GSE, GSH, GSL and PSS series.
Can I use an MWF or MWFP in place of a GSWF?
No. The MWF / MWFP is a larger cartridge for a different housing and will not seat in a GSWF holder.
Does this fit my Kenmore refrigerator?
Yes, if your Kenmore manual or the old cartridge lists 46-9914, 469914 or 9914. Those Kenmore units are GE-built and use this exact filter.
Where do I find my refrigerator model number?
On a label inside the fresh-food compartment — usually on the left interior wall near the crisper drawers, or on the ceiling of the compartment.
My water is coming out slowly after installing the new filter. Why?
Almost always trapped air. Run 1.5 gallons through the dispenser in short bursts. If flow is still restricted, remove the cartridge and reseat it — an under-rotated filter will partially block the water path.
Do I need to turn off the water supply first?
No. The housing has an internal shut-off that closes as soon as the cartridge is removed. Expect a few drips at most.
What happens if I run the filter past six months?
The carbon becomes saturated, chlorine taste and odor start coming back through, and flow rate gradually drops as the media loads with sediment.
